Problemswith Toppik Hair Building Fibers?
Toppik Hair Building Fibers move when too many fibers are applied. When the fibers are applied to the scalp, the keratin protein forms a bond with the hair strand locking them in place. If there are too many fibers and the hair is too thin, then there is very little the fibers can bond with. Excess fibers with no-where to bond to will move freely.
This can be alleviated in two ways; the first method is by simply using less Toppik Hair Building Fibers.
The Toppik Hair Building Fiber clumping is usually due to applying the fibers on wet or overly greasy hair. Your hair is a lot more stable when it is dry as it expands when it is wet.Toppik Hair Building Fibers were scientifically developed for dry hair. When your hair is wet and expanded, the Toppik Hair Building Fibers will still join to the hair follicle, but as the hair follicle dries it begins to contract and become smaller due to the water dissolving from within the follicle. Although it is not enough for you to notice it is enough to really put pressure on the keratin bonds. This will quite literally snap the Toppik Hair Building Fibers, as there are too many bonds in a small space and no-where for the Toppik Hair Building Fibers to retain their individual bonds.
This is not the case when you place Toppik Hair Building Fibers on dry hair, as even if it were to get wet in the future it would expand with the bonds already in place before contracting and not affecting the bonds overall integrity. If purchasing Toppik from Amazon or Ebay always check that the seller is a verified Toppik distributor. Counterfeit offerings could be produced from alternative materials such as cotton, rayon or plant based materials which will not be as effective as genuine Toppik Hair Building Fibers.
Bathroom condensation can cause the Toppik Spray Applicator to become jammed.
To unblock your applicator:
- Rinse it through with some lukewarm water allowing it to dry (at room temperature) before your next use.
- If this first step was not enough to unblock the clogged shaft then try purchasing a pipe cleaner and gently inserting it through the shaft of the applicator, to clean any residue off the inner walls. Once you have used the pipe cleaner, soak the applicator in lukewarm water once again and it allow it to dry fully before your next use.